Back Spray Set Up (Oct 2020) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

Section 5. Setup

5.5 Back Spray Set Up (Oct 2020)

For Q-SUN Xe-3 models with back spray (BS), follow the instructions in
and assemble the Xe-3 exhaust vent. Follow the instructions below to place the Back Spray manifold in the operational
position.
● Open the Xe-3 test chamber door and remove the adhesive tape from the specimen tray.
● Slide the open back specimen tray forward, resting it on the chamber door
● Remove the adhesive tape that secured the Back-Spray manifold in position during shipping.
● Slide the manifold forward until it contacts the front of the chamber below the chamber door
● Then slide the manifold left until it contacts the left side of the chamber
● The manifold is now in the correct operational position.
● See
Section 9 for more information on spray systems.
Open Back
Specimen Tray
Figure 5.5a: Remove Tape. Slide the open back
specimen tray all the way forward.
32
Section 5.1 and Section 5.4
(Figure 5.5a).
(Figure 5.5b [2]).
2
Figure 5.5b: Remove tape. Slide the manifold forward,
then to the left.
to uncrate the Xe-3
(Figure 5.5b [1]).
1