Dual Spray Uncrating And Assembly (Dec 2020) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

5.6 Dual Spray Uncrating and Assembly (Dec 2020)

For Q-SUN Xe-3 models with Dual Spray (DS), follow the instructions in
and assemble the Xe-3 exhaust vent. Follow the instructions below to uncrate and assemble the Dual Spray system.
Uncrating
● The Dual Spray system is shipped in one of two types of crates (
● If the crate has a wooden frame, carefully remove the fasteners and frame boards.
● Cut the straps that hold the fiberboard carton to the skid. Lift off the carton.
● Cut the straps that hold the Dual Spray cart to the skid
● Remove the four side panels and hardware from inside the reservoir.
● At least two people are needed to remove the Dual Spray system from the skid.
● DO NOT attempt to lift the Dual Spray assembly alone.
● Lift the entire cart and reservoir assembly straight up so that the cart wheels clear the skid.
● Move the entire Dual Spray assembly off the skid onto the floor
● See
Section 9 for more information on spray systems.
Cut
Figure 5.6a: This Crate has a Carton Banded to a
Wooden Skid.
Cut
Cut
Figure 5.6c: Cut straps. Remove packing material.
Remove hardware.
(Figure
Remove
Cut
Cut
Cut
Figure 5.6d: Remove Dual Spray assembly from the skid.
Section 5.1 and Section 5.4
Figure 5.6a and Figure
5.6c).
(Figure 5.6d).
Figure 5.6b: This Crate has a Wooden Frame
Surrounding the Carton.
Section 5. Setup
to uncrate the Xe-3
5.6b).
Remove
Reservoir
Cart
33