Section 6. Start Up
6. Start Up
Overview
See LX-5080-TM Q-SUN Xe-3 Technical Manual or LX-5080B-TM Q-SUN Xe-3 Technical Manual for a
complete guide to the programing and operation of the Q-SUN Xe-3 Xenon Test Chamber.
6.1 Specimen Mounting (May 2020)
● Specimens are placed on the tray in the test chamber
● Other specimen mounting configurations are possible. See
mounting guidelines and available holders.
6.2 Q-SUN Xe-3, All "E" Models Control Panel (May 2020)
● The power switch is located on the tester control panel
● Two touch screen displays provide for control and monitoring of tester operation
● The Menu Screen is a control interface that provides functions for setting up and running test cycles, calibration of
sensors, viewing diagnostic information, and display of error messages.
● The Status Screen displays test setup parameters and provides real-time data on actual test conditions
(Figure
6.2d).
48
48
Figure 6.1: Xe-3 Specimen tray pulled out and specimens placed on tray.
Figure 6.2a: Power switch on control panel of all "E" model Xe-3 testers.
(Figure
6.1).
Specification Bulletin LX-5047
(Figure
6.2a).
(Figure
(Figure
6.2c).
for specimen
6.2b).
Xenon Test Chamber
Model Xe-3