Chiller Assembly (Apr 2021) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

5.3 Chiller Assembly (Apr 2021)

● If the Q-SUN tester does not have the chiller option go to Section 5.4.
● Using six of the enclosed #6 screws, attach the Chiller Duct to the rear of the chiller
latch keeper in position as shown.
● Using two #6 screws, loosely attach the Q-SUN duct to the rear panel of the Q-SUN
● Remove the tester right side lower access panel.
● Remove the chiller shroud in front of the air filter (two screws at top and two screws at bottom of shroud,
● From insdie the tester, using two #6 screws, attach the duct to the machine's right rear upright
four screws in the Q-SUN duct.
● Reinstall the chiller shroud
● Using four #6 screws, attach the transition duct to the Q-SUN duct as shown in
● Follow
Step 13 through
1.
Locate the chiller duct assembly (X-6964-X).
Chiller Duct
3. Six (6) screw locations to attach the chiller duct to the
rear of the chiller.
(Step 10).
Step 21 to complete chiller assembly.
Latch
Keeper
(Step 3
(Step 5
Step 11
2.
Notice the latch keeper located on the top of the
duct.
Install X6
4.
Attach the chiller duct assembly to the rear of the
chiller using six (6) Phillips screws (U-5150).
Section 5. Setup
through Step 4) with the
through Step 7).
Step 8).
(Step 9). Tighten the
and Step 12.
Latch
Keeper
25