Safety Information; Heat And Electrical Shock Hazards (Dec 2020) - Q-Lab Q-SUN Xe-3 Series Quick Setup Manual

2. Safety Information

Q-Lab accepts no responsibility for the consequences if the user fails to comply with the instructions in this operating
manual. Q-Lab will accept responsibility for defective parts or components only if the machinery was defective at the time
that the tester was shipped.
● This manual does not claim to address potential safety issues, if any, associated with the use of this product.
● It is the responsibility of the user of this manual to establish appropriate safety and health practices, and to determine
the applicability of regulatory limitations prior to use.
● If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment
safety devices may be impaired.
● The Q-SUN meets the European Low Voltage Directive 2014/35/EU and complies with the requirements of
EN 61010-1: 2010 (Third Edition), "Safety of Electrical Equipment for Measurement, Control and Laboratory Use" .
● The Q-SUN meets the European Electromagnetic Directive 2014/30/EC and complies with the requirements of
EN 55011:2007 Radiated and Conducted Emissions – class A.
● Use only parts that have been supplied or recommended by Q-Lab.

2.1 Heat and Electrical Shock Hazards (Dec 2020)

Warning Labels
● Warning: If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
● Warning labels indicate heat and electric shock hazards inside the Q-SUN tester.
Figure 2.1a: Hot Surface Warning Label
Lamp Door
Left Side
Access Panels
Test Chamber
Door
Lower Front
Door
Figure 2.1c: Tester door and access panel locations.
Right Side
Access Panels
Section 2. Safety Information
Figure 2.1b: Shock Hazard Warning Label
5