Chapter 3 - Options Installation
3-1. Stripper Parts
3-2. Stripper Installation
1.
Open the top cover by pressing
the Cover Open Buttons on both
sides.
2.
Push the front cover piece
buttons inward to open.
3.
Lift/take off the front cover piece
according to the direction shown
in the photo.
4.
Plug in the connector (refer to
the right photo)。
【
】
Notice
There are 2
sockets on the converting
boards (one is for stripper
installation, another is for
cutter installation), before
plug the connector into
socket, please check the
pin first.
5. The label / paper used for
rewinding purposes is
suggested to be at least 30mm
in height.
27
Stripper Module
28
Screw (TAP 3*6) x 2pcs
[NOTE]: Please power off the printer before installing
the stripper module.
20