2.
After entering the tear position adjustment mode, press LF/FF and
LOAD/EJECT keys to change the tear position (the maximum movable
value is based on the factory setting zero position):
❖
"LOAD/EJECT" Press one time, go forward 1/60-inch, max. is
15/60 inch.
❖
"LF/FF" Press one time, go backward 1/60-inch, min. is 0/60 inch.
3.
To exit and save your new setting, press ONLINE key, the Online LED
and will blink twice and the printer makes 2 beeps. The Power LED is
ON. The printer saves the new setting and exits the adjustment mode.
- 16 -