Setting The Alarm - Oregon Scientific RMR166 User Manual

3. The time zone selected will appear to be darkened on the map.
To see the time in a different time zone:
1. Press and release [ZONE] until the desired time zone will be
shown darkened on the display panel. The correct time for
that zone will automatically be displayed.

SETTING THE ALARM

1. Press the [((.))]. The ((.)) symbol will appear on the bottom
line of the LCD screen lower left corner. The alarm time
will also be displayed on the same line of the LCD screen.
2. Press and hold the [((.))] until the hour digits of the alarm
time will begin to flash.
3. Press and release [ ] to increase the hour slowly or press
and hold [ ] to rapidly advance the hour. When setting the
hour, be aware of the AM or PM designation.
4. When the hour is set, press [((.))] again and the minute
digits will begin to flash.
5. Press and release [ ] to increase the minutes slowly or press
and hold [ ] to rapidly advance the minutes.
6. When the alarm time is set, press [((.))] and the alarm will
automatically arm itself. When the alarm is active, a bell
icon will be displayed on the LCD screen just above the ((.)).
To disable the alarm, press [ON/OFF] until the bell icon
disappears.
ACTIVATING/DISABLING THE ALARM
To turn the alarm on or off, press [ON/OFF].
NOTE: When the alarm is on, the bell icon will appear in the
lower left corner of the LCD. If the alarm is off, there will
be no bell icon displayed.
To disable the alarm when the alarm sounds there are two ways to
turn the alarm off:
1. Press [((.))]. The alarm will remain active but will not sound
again for 24-hours.
2. Press [ON/OFF]. The alarm will not sound again until
reactivated.
IMPORTANT: If the alarm is not disabled by either option 1 or 2
above, the alarm will automatically go into "snooze" mode once,
sound again after 8 minutes and then temporarily turn itself off
until the next day.
SETTING THE DAY-OF-THE-WEEK
LANGUAGE CHOICE
The RMR-166 has three language choices for displaying the
day-of-the-week: English, Spanish, and French. To select the
language display choice:
1. Press and hold [MODE] until the hour digits begin to flash.
2. Press [MODE] five (5) more times and a single letter ("E,"
"S," or "F") will be displayed next to the time.
3. Press [ ] until the desired language is displayed.
4. Press [MODE] one more time to lock in language selection
and to return to normal time display mode.
10