Selecting The Time Zone; Setting The Clock Alarm - Oregon Scientific RMR-136HG User Manual

SELECTING THE TIME ZONE

CAUTION: Do not press and hold [ZONE] for more than 3-
seconds. Doing so will deactivate the automatic time signal
reception capability. If the automatic signal reception is disabled,
the signal strength icon will not be displayed. To reactivate the
automatic signal reception, press [
On the bottom line of the LCD screen there is a map outlining the
United States divided into the four US time zones.
1. Press and release [ZONE] to sequentially advance through the
time zones from west to east.
2. The selected time zone will be darkened on the map.
To see the time in a different time zone:
1. Press and release [ZONE] until the desired time zone is
darkened on the map icon. The time will automatically adjust
to that time zone.

SETTING THE CLOCK ALARM

1. Press [((.))]. The ((.)) symbol will appear on the bottom line
of the LCD screen, lower right hand corner. The alarm time
will also be displayed on the same line of the LCD screen.
2. Press and hold [((.))] until the hour digits of the alarm time
begin to flash.
3. Press [ ] to advance the hour selection in increments of
one hour, or press and hold for rapid advancement.
] for three seconds
NOTE: When setting the hour, be aware of the AM/PM
designations.
4. When the hour has been selected, press [((.))] again and
the minutes digits of the alarm time will begin to flash.
5. Press [ ] to advance the minute selection inincrements of
one minute, or press and hold for rapid advancement.
6. When the alarm time is set, press [((.))]. The alarm will
automatically activate itself. The active alarm status is
indicated by the bell icon just above the ((.)) symbol.
ACTIVATING/DISABLING
THE CLOCK ALARM
To active the daily alarm, press [AL ON/OFF]. When the alarm
is active, a bell icon will appear in the lower left corner of the
LCD screen. If the alarm is not active, there will be no bell icon.
When the alarm sounds there are two ways to turn it off:
1 Press [((.))]. The alarm will remain active but will not sound
again for 24-hours.
2. Press [AL ON/OFF]. The alarm function is disabled and will
not sound again until reactivated.
IMPORTANT: The RMR-136HG has an automatic snooze
feature. If the alarm is not disabled by either option 1 or 2 above,
the alarm will automatically go into "snooze" once, sound again in
8 minutes and then temporarily turn itself off for 24-hours.
11