Clock Reception Signal; Alarm; Clock Reception - Oregon Scientific BAR669 User Manual

BAR669A:
• WWVB-60 generated from the atomic clock in Collins,
Colorado.
The radio signal range is 3219km (2000 miles).
NOTE BAR669: Slide the EU / UK switch to the
appropriate position for your location. Repeat each time
you reset the unit.
NOTE Initial reception takes 2-10 minutes for first set
up or when RESET is pressed. Light box will toggle red
/ green during reception. Once complete, the reception
icon will stop blinking. If the signal is weak, it can take
up to 24 hours to get a valid signal.

CLOCK RECEPTION SIGNAL

STRONG WEAK
To enable clock signal reception:
Press and hold for two seconds.
To disable clock signal reception
Press and hold for two seconds.
P/N:086L004448-011EN REV1
BAR669 EN op.indd 4
4/11
CLOCK
To set the clock:
1. Press and hold CLOCK to enter clock setting
mode. The setting will blink.
2. Use
3. Press CLOCK to confirm and move onto the next
setting. The setting sequence is: time zone offset,
12 / 24 hour format, hour, minute, preset light time
ON, preset light time OFF.
NOTE The time zone offset can be used to set the
clock up to + / - 23 hours from the received clock signal
time.
BAR669A: Time zone offset can be set to the US
time zone: (P) Pacific, (M) Mountain, (C) Central or
NO SIGNAL
(E) Eastern.

ALARM

To set the alarm:
1. Press
when you are in the alarm display.
2. Press and hold
setting will blink.
4
/ to change the setting.
to switch to alarm display.
to enter alarm setting mode. The
appears
4/19/06 11:19:13 AM