ABOUT OREGON SCIENTIFIC Wireless Visit our website (www.oregonscientific.com) to learn more about other Oregon Scientific products such as digital cameras, hand-held organizers, health and fitness gear, and projection clocks. The website also includes contact information for our customer service department, in case you need to reach us.
PRODUCT OVERVIEW FRONT VIEW RMR603HGA lab test R2 SNOOZE / LIGHT: Press to activate backlight or snooze. Temperature Area: Readings, trend line, sensor reception status and channel number Humidity Area: Readings; trend line, and sensor battery status Clock / Alarm Area: Time, time zone, day of week,...
BACK VIEW RMR603HGA lab test R2 Wall mount Battery compartment °C / °F switch ZONE: Press to switch time zones, deactivate Atomic Clock signal reception RESET hole Table stand 1/17/04, 4:52 PM...
INDOOR humidity is shown. Remote Humidity Area when the OUTDOOR humidity is shown. RMR603HGA lab test R2 CHANGE SETTINGS Press and hold MODE for 2 seconds to enter setting mode. Press UP or DOWN to change settings. Press MODE to confirm.
Close the remote sensor battery compartment. Secure the sensor in the desired location using the wall mount or table stand. RMR603HGA lab test R2 For best results: • Insert the batteries and select the channel and temperature unit before you mount the sensor.
This is normal and does not affect general product performance. The reception will resume once the interference ends. RMR603HGA lab test R2 CLOCK This product shows the current time, time zone, and day of week in English, Spanish, or French. The time is automatically updated by the US Atomic Clock in Boulder, Colorado unless you disable this feature.
Press UP or DOWN to change the setting. Press MODE to confirm. NOTE The language options are (E) English, (F) French, and (S) Spanish. RMR603HGA lab test R2 SWITCH CLOCK DISPLAY Press MODE to toggle between Clock with Seconds, Clock with Weekday and Calendar. ALARM This product is equipped with a 2-minute crescendo alarm and 8-minute snooze.
• Current, minimum and maximum readings • Trend line Data is collected by the remote sensors and displayed every 40 seconds. RMR603HGA lab test R2 SELECT TEMPERATURE UNIT Slide the °C / °F switch into the desired location. The shows switch is located in the battery compartment.
The trend lines are shown next to the Temperature and Humidity readings. Trend Rising Steady ICON RMR603HGA lab test R2 BACKLIGHT Press SNOOZE/LIGHT to activate the backlight for 5 seconds. RESET SYSTEM The RESET buttons are located in the battery compartments for the main unit and sensors.
Unauthorized changes may void your right to use the product. The technical specification of this product and contents of this user guide are subject to change without notice. Images not drawn to scale. RMR603HGA lab test R2 TROUBLESHOOTING Check here before contacting our customer service department.
Resolution Memory Min / Max RELATIVE HUMIDITY Range 25% to 95% Resolution Memory Min / Max RMR603HGA lab test R2 REMOTE SENSOR (THGR122NX) RF frequency 433 MHz Range 30 meters (98 feet) with no obstructions Transmission every 40 seconds Channel No.
RMR603HGA lab test R2 • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.
Page 16
Phase 1, 41 Man Yue St., Hung Hom, Kowloon, Hong Kong RMR603HGA lab test R2 is in conformity with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference.