Oregon Scientific RMR-136HG User Manual page 4

2. Insert batteries into the remote sensor BEFORE inserting
batteries into the main unit.
3. Press [RESET] on the main unit after installing the batteries.
Place the main unit close to the remote sensor as this will
expedite initial signal synchronization between the main unit
and the remote sensor.
4. Position the remote sensor within the effective transmission
range of 21 - 32 yards (20 - 30 meters) from the main unit.
See "Wireless Transmission" for important information about
wireless data transmission.
Note: Although the remote sensor has been designed for outdoor
use, do not place the remote sensor in direct sunlight, rain or snow.
REMOTE SENSOR BATTERY
INSTALLATION & CHANNEL SELECTION.
To install / replace batteries:
1. Remove the screws on the battery compartment.
2. Using the [CHANNEL] slide switch, select the channel
number of 1, 2 or 3 for that remote sensor.
3 The temperature can be displayed in either Celsius or
Fahrenheit. Slide the [ C/ F Slide Switch] to either "C" or
"F."
4. Insert the batteries according to the polarities as shown.
5. Press [RESET].
6. Replace the battery compartment door and secure its screws.
NOTE: Once a channel is assigned to a remote sensor, it can only
be changed by removing and then reinserting the batteries or
resetting the remote sensor.
MAIN UNIT BATTERY INSTALLATION
To install / replace batteries:
1. Gently lift the tab on the battery compartment door and slide
to remove door.
2. Install the batteries strictly according to the polarities shown.
3. Press [RESET].
4. Replace the battery compartment door.
4
Model No. RMR136HG
Remote Therm-Hygro
FOR HOME OR OFFICE USE