Bosch PXI-CORE Edge controller User Manual page 11

PXI-CORE Edge controller
–
Mount the device on a 35 mm standard mounting rail. The preferred overall height of the
mounting rail is 7.5 mm (corresponds to TH 35‑7.5 acc. to EN 60715).
To mount on a mounting rail:
1.
2.
Dismounting from a mounting rail
To dismount from a mounting rail:
1.
2.
Bosch Security Systems B.V.
IMPORTANT: Connect the voltage only after the device is mechanically and electrically
mounted correctly.
Seat the bottom of the clip into the bottom channel of the rail. Then, press it in and up
slightly until it clicks into place.
Mount the device only vertically to ensure air cooling in the device:
– For sufficient cooling, provide at least 35 mm of free space to front, rear, top and
bottom sides of the device. The natural convection supports the forced cooling air
flow. Heat pockets can thus not result in the device.
For information on ambient temperatures, refer to Technical data, page 25 .
–
Disconnect the device from voltage and other connections.
Use a suitable tool (e.g. slotted screwdriver), and put it into the lower disengaging
mechanism (base latch) of the device.
Detailed installation procedures and instructions | en
User manual
11
2023-03 | V01 | F01U395004