Table of Contents
Advertisement
16
en | Detailed installation procedures and instructions
4.
Figure 4.2: Reattaching the press fit plug
5.
Notice!
i
IMPORTANT
The 24 VDC voltage supply has to be routed separately from lines carrying higher voltages.
6.
Notice!
i
The power connector LED will light up green when connected and inserted correctly in the
PXI-CORE edge controller.
4.2.3
SD card slot CF01
The SD‑card slot (CF01) on the front of the device is provided to plug in a micro SD‑card. It
can be used to extend the internal device memory to hold firmware update files.
2023-03 | V01 | F01U395004
When the bottom fit of the plug lands on the horizontal pins of the device, engage the
plug upwards and towards the connector holder on the device. You hear a click noise
when the connector is locked in the final position.
Connect the other side of both wires to the 24 VDC output of the power supply device,
observing polarity:
–
wiring color convention: red for + and black for -.
Connect the primary mains/AC power supply voltage, and power on the 24 VDC power
supply device:
–
Continue with Power on.
User manual
PXI-CORE Edge controller
Bosch Security Systems B.V.
Advertisement
Table of Contents
