Electrical Installation - Bosch PXI-CORE Edge controller User Manual

PXI-CORE Edge controller
4.2

Electrical installation

The PXI‑CORE edge controller communicates with your configuration device via Ethernet port
XF51 connected to an Ethernet network, and is DC‑powered from an external 24 VDC power
supply. If required, the XF10 Ethernet port can be used for connection to your computer (PC).
Caution!
Attaching and detaching connections under voltage can damage the device!
!
Switch off and/or disconnect the supply voltage before attaching or detaching any
connections!
Item
A
B
D
C
E
F
G
H
Cabling precautions
–
–
–
–
–
–
Bosch Security Systems B.V.
A
B
C
H
D
E
F
G
Connection Function
XF01 USB female connector, type C.
XF10 Ethernet 10/100/1000 Mbit
XF51 sockets
XF50 Not used
CF01 SD‑card slot
XD10 24 VDC input socket
GB01 Battery case
- LED bar
Do not route cables parallel to motor cables or other strong interference sources to avoid
the coupling of interferences.
The Ethernet cabling may not leave the building.
Observe the bending radius of the cables used when laying the connecting lines.
Use strain reliefs for all cables.
Keep the maximum possible distance from interference sources.
Refer to Technical data, page 25 .
Detailed installation procedures and instructions | en
User manual
Type Manual section
USB 2.0
Ethernet ports, page
RJ45, 8‑pin
14
Micro SD card slot CF01,
SD‑card page 16
2‑pin (2‑wire) Power supply XD10,
page 14
Battery case GB01,
-
page 17
LED Booting
2023-03 | V01 | F01U395004
13