Set-Up Communication Parameters In Windows - ABB AC500 V2 Getting Started

8.

1.3.3 Set-up communication parameters in Windows

Setting up com- To set up the communication between the PC and the PLC, e.g., for downloading the compiled
munication program, you have to set up the communication parameters.
parameters
The IP address of your PC must be in the same class as the IP address of the CPU.
The factory setting of the IP address of the CPU is 192.168.0.10.
The IP address of your PC should be 192.168.0.X. Avoid X = 10 in order to prevent an IP
conflict with the CPU.
Subnet mask should be 255.255.255.0.
Change the IP 1.
address
2.
3.
4.
2023/03/03
Engineering software Automation Builder > Set-up communication parameters in Windows
Select "OK" to end the wizard.
ð Automation Builder license is activated and starts.
Open Windows control panel. Click "Network and Internet è Network and Sharing
Center".
Click "Change adapter settings".
ð
If using existing network with several devices, please pay attention on
given network rules or contact your system administrator.
Right-click "Local Area Connection (Ethernet)" and select [Properties].
Double-click "Internet Protocol Version 4 (TCP/IPv4)".
3ADR010649, 3, en_US
Getting started with example projects
9