Control 4 C4-KNX-THERM Series User Manual page 32

Display Operating mode
Standby:
– Standby mode lowers the temperature during absence below the level of
comfort mode. This saves energy. And the room does not cool down during an
extended absence.
Dew point:
– If an appropriate telegram is received from a dew point sensor, the room
temperature controller will display the corresponding icon and cease cooling and
merely protect against the heat.
Alarm:
– The alarm can be freely parameterized. For example, it can occur when an
external temperature sensor no longer sends values.
On/Off:
– The room temperature controller can be activated and deactivated. If control is
deactivated, this icon appears in the display. The device operates in frost
protection mode.
ECO mode:
– The heating/cooling output is extremely lowered.
Frost protection:
– If parameterized, frost protection will ensure that the temperature does not drop
below the desired value. It is the lowest setpoint.
Heat protection:
– If parameterized, heat protection will ensure that the temperature does not
exceed the desired value. It is the highest setpoint.
Condensate:
– The operation of a fan coil may cause condensate water, which is collected in a
container. If the fan coil sends out a telegram when the container is full, the icon
for condensate mode is displayed. The room temperature controller switches
automatically into heat protection mode.
NOTE
Local operation is blocked!
–
The alarm or the operating mode must first be deactivated.
Notes on the instruction manual
│32