Table of Contents
Advertisement
To start the device a physical address must be assigned first. The physical address is assigned,
and the parameters are set with the Engineering Tool Software ETS (ETS 5.6.6 or higher).
NOTE
The devices are products of the KNX system and meet KNX guidelines. Detailed
expert knowledge by means of KNX training sessions for a better understanding
is assumed.
1.
Connect a PC to the KNX bus line via the KNX interface.
–
The Engineering Tool Software ETS 5.6.6 (or higher) must be installed on the PC.
2. Switch on the bus voltage.
NOTE
Please observe the operating manual for the flush-mounted bus/network coupler
which is to be ordered separately.
The group addresses are assigned in connection with the ETS.
Download
The application program is available for download at
Name: SBR/U2.1.41-83).
The application is loaded into the device via the ETS (5.6.6 or higher).
Various functions can be implemented via the software application (ETS; 5.6.6 or higher).
–
Detailed description of parameters: see chapter 10 "Description of application and
parameters" on page 34
Notes on the instruction manual
https://ctrl4.co/knx-therm
(KNXPROD File
│24
Advertisement
Table of Contents
