Grandstream Networks HT818 Administration Manual page 8

Menu Voice Prompt
07 Preferred Vocoder
10 "MAC Address"
WAN Port Web
12
Access
Firmware Server IP
13
Address
Configuration Server
14
IP Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
86 Voice Mail
99 "RESET"
"Invalid Entry"
"Device not
registered"
Five success tips when using the voice prompt
Options
Press "9" to move to the next selection in the list:
PCM U / PCM A
iLBC
G-726
G-723
G-729
OPUS
G722
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the WAN port and one for the LAN port. The
device MAC address announced is the address of LAN port.
Press "9" to toggle between enable / disable.
Default is disabled.
Announces current Firmware Server IP address. Enter 12-digit new IP address.
Announces current Config Server Path IP address. Enter 12-digit new IP address.
Upgrade protocol for firmware and configuration update. Press "9" to toggle between
TFTP/HTTP/HTTP /FTP/FTPS
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the following three options:
Always check
Check when pre/suffix changes
Never upgrade
Enter the target IP address to make a direct IP call, after dial tone.
Access to your voice mails messages.
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook If the device is not registered and the
option "Outgoing Call without Registration" is in NO
Table 5: Voice Prompt Menu