Switch on the power to the air-conditioner at the isolation breaker.
●
Using the remote control , start the air-conditioner by pressing "
●
function by pressing the "MODE" button.
Operate in low FAN, medium FAN and high FAN in turn to check normal operation.
●
Select COOL mode, adjust the set point temperature to three degrees lower than the room temperature,
●
the unit will start to blow cool air after the compressor starts.
Select HEAT mode, adjust the setting temperature to three degrees higher than the room temperature,
●
the unit will start to blow warm air after the compressor starts.(Valid only for heat pump units)
After selecting the COOL or HEAT mode, the compressor may delay starting
for 3 minutes. This is a feature to protect the compressor.
Quick Start Guide
Note
13
" button and then select fan