Switch on the power to the air-conditioner at the isolation breaker.
●
Using the remote control , start the air-conditioner by pressing "
●
function by pressing the "MODE" button.
Operate in low FAN, medium FAN and high FAN in turn to check normal operation.
●
Select COOL mode, adjust the set point temperature to three degrees lower than the room temperature,
●
the unit will start to blow cool air after the compressor starts.
Select HEAT mode, adjust the setting temperature to three degrees higher than the room temperature,
●
the unit will start to blow warm air after the compressor starts.
Press the LIGHT key, turn on /off the plenum LED light.(Valid only for units with LED lighting )
●
Press the DIM key, operate in 25% brightness,50% brightness,75% brightness and 100% brightness in
●
turn to check normal operation.(Valid only for units with LED lighting )
Press the wall-mounted switch for LED lights to turn on or turn off the LED lights.
●
( valid only for units with LED lighting and wall-mounted switch )
Turn off mains power supply, turn on the remote control, select the "LIGHT" key to turn on or turn
●
off the LED lights . ( valid only for units with LED lighting and storage battery )
After selecting the COOL or HEAT mode, the compressor may delay starting
for 3 minutes. This is a feature to protect the compressor.
Quick Start Guide
Note
10
" button and then select fan