Adding To The System - AJAX FireProtect 2 User Manual

Adding to the system

Before adding a device
1. Install the Ajax app
2. Create an account
3. Add a hub compatible with the detector
and create at least one
4. Make sure that the hub is on and has Internet access via Ethernet, Wi-Fi,
and/or mobile network. You can do this in the Ajax app or by looking at the
LED indicator of the hub: it should light up white or green.
5. Make sure that the hub does not start updates and that it is disarmed by
checking the status in the Ajax app.
A PRO or a user with system setup rights
To connect to the hub, the detector should be within the coverage area of the
hub radio network. To operate via a
the detector to the hub and then to the range extender. You can do this in the
range extender settings in Ajax apps.
How to connect FireProtect 2 to a hub
1. Open the Ajax app
2. Select the hub if you have several of them or if you are using the
app .
3. Go to the Devices
4. Enter the name of the device.
.
if you don't have one.
virtual room
radio signal range extender
.
tab. Press Add Device.
to the app. Set the required settings
.
can connect the device to the hub.
, rst connect
Ajax PRO