AJAX FireProtect 2 User Manual page 8

5. Scan the QR code or enter the ID manually. QR code is located on the rear
part of the enclosure (under the mounting panel) and on the device
packaging. The device ID can be found below the QR code.
6. Select the virtual room
7. Click Add; the countdown will begin.
If the maximum number of devices is added to the hub, when adding the one, you
will get a noti cation of exceeding the device limit. The number of devices that you
can connect to the hub depends on the
8. Turn on the detector by holding the power button for 3 seconds. The hub
connection request is sent only if the detector is enabled. If the detector
fails to connect to the hub, try again in 5 seconds.
The detector cannot connect to the hub if they operate on different radio
frequencies. The radio frequency range of the devices may vary by the region of
sale. Please contact
range of your devices.
Once connected, FireProtect 2 will appear in the hub device list in the Ajax app.
Device status update depends on the ping interval set in the Jeweller or
Jeweller/Fibra settings. The default value is 36 seconds.
FireProtect 2 works with only one hub. When connected to a new hub, the
detector stops transmitting data to the old hub. Once added to a new hub,
FireProtect 2 is not removed from the list of devices of the old hub. This must be
done manually in Ajax apps.
Indication
and security group (if the
central unit model
technical support for information on the operating frequency
group mode is enabled).
.