In-situ Aqua TROLL 600 Operator's Manual page 25

d
Apply a pea-sized drop of
lubricant to O-rings.
g
Unscrew end cap from restrictor.
When using a conductivity sensor and turbidity sensor together, install them side-by-side to
maximize performance.
3 Connect the cable to the instrument.
Remove protective caps
from instrument and
cable.
1-970-498-1500
e
Align sensor with interlock groove
in wiper motor and slide sensor
into port.
h
Flip restrictor and install with
restrictor holes near center of
instrument for calibration.
Ensure O-ring on
instrument connector
is clean. Apply vacuum
grease to O-ring.
Tighten set-screw at base of each
sensor.
Flip restrictor and replace end cap
before deployment.
Flat edge inside cable
end must align with
flat edge on instrument
connector.
32
f
i
Hold textured sleeve of
cable in one hand and
instrument in other. Push
and twist until click.
www.in-situ.com