First Time Setup; Automatic Speaker Setup - Onkyo HT-S7100 Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Automatic Speaker Setup

With the supplied calibrated microphone, Audyssey
®
2EQ automatically determines the number of speakers
connected, their size for purposes of bass management,
optimum crossover frequencies to the subwoofer (if
present), and distances from the primary listening posi-
tion. Audyssey 2EQ then removes the distortion caused
by room acoustics by capturing room acoustical prob-
lems over the listening area in both the frequency and
time domain. The result is clear, well-balanced sound for
everyone. Enabling Audyssey 2EQ allows you to also
use Audyssey Dynamic EQ, which maintains the proper
octave-to-octave balance at any volume level. (See
page 70)
Measurement Positions
To create a listening environment in your home theater
that all listeners will enjoy, Audysssey 2EQ takes mea-
surements at up to three positions within the listening
area.
A
First measurement point
This is the center point of the listening area, or the
listening position.
B
Second measurement point
The right side of the listening area.
C
Third measurement point
The left side of the listening area.
The distances between points
3
and must be at least 1 meter.
From the examples below, choose the listening area that
best matches yours and place the microphone accord-
ingly when prompted.
TV
TV
TV
:
Listening area
:
Listening position
38
1 2 1
and and points
TV TV
TV TV
TV TV
Using Audyssey 2EQ
Notes:
• If any of your speakers is 4 ohms, change the
Speaker Impedance setting before running the
automatic speaker setup (see page 42).
• If the AV receiver is muted, it will be unmuted
automatically when the automatic speaker setup
starts.
• Automatic speaker setup cannot be performed
while a pair of headphones is connected.
• It takes about 10 minutes to complete the auto-
matic speaker setup for three positions. Total mea-
surement time varies depending on the speakers.
• Do not connect or disconnect any speakers during
the automatic speaker setup.
1
ON/STANDBY
STANDBY ZONE 2
PURE AUDIO MULTI CH DVD VCR/DVR CBL/SAT GAME/TV
PHONES
ZONE 2 OFF ZONE 2 LEVEL TONE MOVIE/TV
2, 8
3-7
The onscreen setup menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected
to the composite video or S-Video MONITOR OUT,
or the COMPONENT VIDEO OUT, use the TX-
SR606's display when changing settings.
1
Turn on the AV receiver and the
connected TV.
ON/STANDBY
On the TV, select the input to which the
AV receiver is connected.
®
MASTER VOLUME
TUNING PRESET
AUX TAPE TUNER CD SETUP ENTER RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
MUSIC GAME DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
TX-SR606
AV RECEIVER