Equalizer Settings - Onkyo HT-S7100 Instruction Manual

Advanced Setup—Continued

Equalizer Settings

These settings are set automatically by the Automatic
Speaker Setup function (see page 38).
Here you can adjust the tone of individual speakers. To
set the volume of individual speakers, see page 75.
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press the
[ENTER] button.
3
Use the Up and Down [
buttons to select "5. Equalizer
Settings," and then press
[ENTER].
4
Use the Left and Right [
buttons to select:
Audyssey: The tone for each speaker
If you selected Manual, continue with
this procedure. If you selected Off or
Audyssey, go to step 8.
76
Off: Tone off, response flat.
is set automatically by the
Automatic Speaker Setup
function. Be sure to select
this setting after having
performed the Automatic
Speaker Setup.
Manual: You can adjust the equal-
izer for each speaker
manually.
5
6
]/[ ]
7
]/[ ]
]/[ ] 8
Notes:
• The front, center, surround, and surround back speak-
ers can be adjusted at 63Hz, 250Hz, 1000Hz, 4000Hz,
and 16000Hz. The subwoofer can be adjusted at 25Hz,
40Hz, 63Hz, 100Hz, and 160Hz.
• While the Direct or Pure Audio listening mode is
selected, the equalizer settings have no effect.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Press the Down [ ] button, and
then use the Left and Right
[ ]/[ ] buttons to select a
speaker.
2–5. Equalizer Settings
Equalizer Manual
Channel
63Hz
250Hz
1000Hz
4000Hz
16000Hz
Use the Up and Down [
buttons to select a frequency.
Use the Left and Right [
buttons to adjust the level at that
frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 63Hz)
affect bass sounds; high frequencies
(e.g., 16000Hz) affect treble sounds.
Use the Up [ ] button to select
"Channel," and then use the Left
and Right [ ]/[ ] buttons to
select another speaker.
Repeat steps 5 and 6 for each speaker.
Speakers that you've set to No or None
in the Speaker Configuration (page 72)
cannot be selected.
Press the [SETUP] button.
The setup menu closes.
Front
0dB
0dB
0dB
0dB
0dB
]/[ ]
]/[ ]