Onkyo HT-S7100 Instruction Manual page 41

First Time Setup—Continued
Auto Speaker Setup
- - - - - Speaker Detect Error - - - - -
FL : Yes
SL : ---
SBL : No
C : Yes
Retry
Cancel
The right surround back speaker has been detected
but the left surround back speaker hasn't.
Auto Speaker Setup
- - - - - Speaker Detect Error - - - - -
FL : Error
SL : Yes
SBL : Yes
C : Yes
Retry
Cancel
There is a problem with a speaker. The speaker may
be broken or the subwoofer may be emitting sound
that is too high.
Auto Speaker Setup
Speaker Detect Error
Retry
Cancel
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are con-
nected properly.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
❏ Write Error
Auto Speaker Setup
Writing Error!
Retry
Cancel
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact your Onkyo dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
AUDYSSEY
FR : Yes
SR : Yes
SBR : Yes
SW : ---
AUDYSSEY
FR : Yes
SR : Yes
SBR : Yes
SW : Yes
AUDYSSEY
AUDYSSEY
To Retry the Automatic Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be
detected are connected properly.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the automatic speaker setup, follow the directions on
pages 72–76.
Using a Powered Subwoofer
If you're using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by the automatic speaker setup. If the sub-
woofer (SW) appears on the "SP Detect Result" screen
as "No", increase the subwoofer's volume to the half-
way point, set it to its highest crossover frequency, and
then try running the automatic speaker setup again. Note
that if the volume is set too high and the sound distorts,
detection issues may occur, so use an appropriate
volume level.
41