Related Manuals for Belmont RAPID INFUSER RI-2
Summary of Contents for Belmont RAPID INFUSER RI-2
- Page 1 QUICK REFERENCE GUIDE IT IS ESSENTIAL THAT YOU READ AND UNDERSTAND THE OPERATOR’S MANUAL BEFORE USING THIS DEVICE Registered in Accordance with ISO 13485...
-
Page 2: Pole Mounting
Pole Clamp Release Handle approximately 30” from the ground. • Mount The Belmont ® Rapid Infuser RI-2 RI-2 UNIT above the Pole Mount Support Assembly. • Push the “Pole Clamp Release Handle” down to lock the RI-2 onto the IV Pole. - Page 3 Plug the main connector of the detachable power cable into a dedicated circuit breaker. Fully seat the device connector Quick Setup ® (C-19) of the power cable into the power receptacle on the back of The Belmont Rapid Infuser RI-2. If a moisture guard is Guide present, ensure it is over the device connector and flat against the back of the machine.
- Page 4 REPLACING RESERVIOR CHAMBER / INSTALLING 3 LITER RESERVOIR Replace Filter / Standard Reservoir Chamber (Fluid Supply) Install 3 Liter Reservoir Reservoir Chamber Clamp this off before removing the reservoir chamber Disconnect luer lock and quick connector to Connect 3.0 Liter Reservoir to remove the chamber the 3-Spike Disposable Set REPLACING RESERVOIR CHAMBER...
-
Page 5: Operational Alarms
OPERATIONAL ALARMS ALARM / MESSAGE POSSIBLE CAUSES SOLUTION UNIT DOES NOT POWER UP • Power switch not completely depressed • Depress power switch completely AIR DETECTION • Air in the line • Open door, squeeze tubing directly below air detector sensor to clear air. •... - Page 6 Call technical support SYSTEM PARAMETERS SETTING The CALIBRATION/SET-UP screen is accessed by pressing SERVICE key during power-up This key appears on the BELMONT logo screen and remains active for 4.5 seconds before system enters the PRIME screen. DATE/TIME DISPLAY BRIGHTNESS •...
- Page 7 Rapid Infuser Incompatible Solutions Solution Description Compatible? Conversions & Heating Sodium Bicarbonate Solutions Heats to 39° C Heats to 37.5° C mL/min mL/hr mL/min mL/hr ½ NS 0.45% NaCl 3600 3% NS 3% NaCl 4200 Platelets Should not be diluted, stick to tubing 4800 Cryoprecipitate Should not be diluted...
Need help?
Do you have a question about the RAPID INFUSER RI-2 and is the answer not in the manual?
Questions and answers