Assa Abloy Yale 5300LN Series Parts And Service Manual page 21

INSTALLATION INSTRUCTIONS
5. Adjust lock for door thickness. If necessary
(Lock is packed preadjusted for 1-3/4"(44mm) doors.)
A. Remove lever and rose assembly (as one unit)
from lock body by removing two (2) screws.
B. Disengage rose plate from lock body and reinstall
per illustration below.
C. Assemble lever and rose assembly to the lock
body and secure with screws.
D. Adjust button as required (5302, 5303, 5307, and
5322 locks only). Depress retainer and adjust as
shown below.
Retainer Position
1st
1 3/8" Door
(35mm)
2nd
1 3/4" Door
(44mm)
6. Install lock.
Insert lock body into door from
outside making sure that lock
body frame hooks latch case
and retractor engages bolt
tail(s).
DO NOT FORCE. (If lock body
does not engage latch easily,
check door preparation for
errors.)
Retractor
Latch
engages bolt
tail(s)
Lockbody
Frame engages
latchcase
5300LN Series Parts & Service Manual
Position for thick doors
STD lock : 1-3/4" door
OPT lock : 2-1/4" door
3rd
2" & 2 1/4"
Door
(51mm & 57mm)
Slide plate to disengage
Outside Rose Plate Adjustment
7. Install inside components
A. Slide inside rose support assembly onto lock body and tighten through bolts.
B. Place rose scalp on rose support assembly, aligning the dimple with the
notch. Rotate the rose scalp clockwise to lock. Note: Repeat on outside rose
if necessary.
C. Install lever handle.
and lever as shown on the next page.
Inside Rose
Support Assembly
Rose Scalp
September 2003
Position for thin doors
STD lock : 1-3/8" door
OPT lock : 2" door
For double cylinder functions, install the inside cylinder
Through Bolt
Turnbutton
Inside Lever
Page 21