Table of Contents
Advertisement
Figure 1- 1. CE-label.
1.3 Site conditions
The machinery is to be used on a site with conditions according to Technical
Specifications and Conditions laid down by ABB in their contract with the user,
and nowhere else.
1.4 Important note
The information in this document may sometimes be of a general nature and
applicable to various machines supplied by ABB.
Where a conflict exists between the contents herein and the actual machinery
supplied, the user must either make an informed engineering judgment as to a
course of action or, if any doubt exists, contact ABB.
The safety precautions shown in this chapter and elsewhere in this User's Manual
must be observed at all times.
Safety is dependent on the awareness, concern and prudence of all those who
operate and service machines. While it is important that all safety procedures will
be observed, care near machinery is essential.
NOTE: To avoid accidents, safety measures and devices required at the
The information in this document is subject to change without notice and should
not be construed as a commitment by ABB. ABB assumes no responsibility for
any errors that may appear in this document.
This document and parts thereof must not be reproduced or copied without the
express written permission of ABB, and the contents thereof must not be imparted
to a third party nor be used for any unauthorized purpose.
1.5 Limitation of liability
In no event shall ABB be liable for direct, indirect, special, incidental or
consequential damages of any nature or kind arising from the use of this
document, nor shall ABB be liable for incidental or consequential damages arising
from use of any software or hardware described in this document.
The warranty issued covers manufacturing and material defects. The warranty
does not cover any damage caused to the machine, personnel or third party by
improper storage, incorrect installation or operating of the machine. The warranty
conditions are in more detail defined according to Orgalime S2000 terms and
conditions.
NOTE: The warranty issued is not valid, if the operation conditions of the
installation site must be in accordance with the instructions and
regulations stipulated for safety at work. This applies to general safety
regulations of the country in question, specific agreements made for
each work site and safety instructions included in this manual and
separate safety instructions delivered with the machine.
machine are changed or any changes in the construction of the machine,
Page 6
Advertisement
Table of Contents
