Button Bar - Analog Devices AD9912 Quick Start Manual

I/O Menu
Select Evaluation Board
The AD9912 evaluation system allows one PC to control
multiple evaluation boards. This command allows the user to
select which evaluation board the software controls.
DUT I/O Configure
This command selects 3- or 4-wire serial port mode, LSB first,
and contains a button for a soft I/O reset.
Window Menu
This menu allows the user to select any of the 14 windows that
are associated with the major functional blocks of the AD9912.
These windows are also accessible by going to the Interactive
Block Diagram window and clicking the block of interest. See
the Evaluation Software Functional Blocks section for a
description of each of these windows.
Help Menu
Selecting Help brings up the About AD9912 splash screen. It
contains information such as revision number, region informa-
tion, and contact information.

BUTTON BAR

The following buttons are provided for easy access to common
features.
Load Eval Board Setup/Save Eval Board Setup
These buttons allow the user load/save a AD9912 setup file
(.STP). A setup file is a text file that contains the AD9912
register setup file, plus any evaluation board settings.
Note that when saving register setup files, it is important to
select single-tone mode before saving the file. Register setup
files are loaded into the AD9912 sequentially, and the loop
should only be locked once all registers are loaded. Otherwise,
the part may need to be reset.
Reset
This button resets the evaluation board and restores the
AD9912 to its default power-up state.
I/O Update
This button toggles the IO_UPDATE pin on the AD9912.
Block Diagram
This button selects the Interactive Block Diagram window.
Debug Window
This button selects the Debug window. See the Debug Window
section for a description.
Rev. 0 | Page 7 of 12
AD9912/PCBZ