Epson PowerLite Pro G5450WU User Manual page 158

Solving Problems
158
Make sure the projector is plugged in.
■
Make sure the LAN cable is connected correctly. Reconnect it if it
■
is not connected or it is not connected correctly (see page 76).
For problems with the EasyMP Network Projection software, see the
EasyMP Network Projection Operation Guide.
For problems with the EasyMP Multi PC Projection software, see the
EasyMP Multi PC Projection Operation Guide.
For problems with EasyMP Monitor (available for Windows only), see
the EasyMP Monitor Operation Guide.
You can also check the Event ID in the projector when you have
network related problems:
1. Press the button and highlight the
Menu
2. If you see an
Event ID
following table for additional information:
Event ID Description
0432 EasyMP Network Projection failed to start. Turn the
projector off and then back on.
0435
0434 Network communication is unstable. Check the status of
your network. Wait a few moments, then try connecting to
0481
the projector again.
0482
0485
433 A transferred image cannot be projected. Restart EasyMP
Network Projection.
484 There was a network communication problem. Restart
EasyMP Network Projection.
04FE Check the status of your network. Turn the projector off
and then back on.
0891 There is a an SSID problem. Set the computer, access
point, and projector to the same SSID.
0892 There is a problem related to WPA or WPA2 authentication.
Check the setting wireless LAN security setting in the
projector (page 93).
Info
at the bottom of the menu, refer to the
menu.