Using the Projector on a Network
108
Using the Tools Tab
Select the
tab in the top right corner of the window to display
Tools
the window shown below:
1. Enter settings for Crestron
section of the window.
Control
2. Enter settings in the
■
Enter a
Projector Name
projector from other projectors on the network (up to 15
single-byte alphanumeric characters).
Enter a
■
Location
alphanumeric characters).
Enter a user name for the projector in the
■
(up to 32 single-byte alphanumeric characters).
Click the
■
Enabled
If you're not using DHCP, enter an
■
projector.
Enter a
■
Subnet Mask
projector.
3. Click
to register the changes you made in the
Send
section of the window.
®
central controllers in the
section of the window:
Projector
to differentiate the current
name for the projector (up to 32 single-byte
checkbox to use DHCP.
IP Address
and
Default Gateway
Crestron
box
Assigned To
for the
address for the
Projector