Epson PowerLite Pro G5450WU User Manual page 117

■
Resolution
Set to to have the projector automatically identify the
Auto
resolution of the input signal. If necessary (because some of
the image is missing, for example), adjust to
. You can also select
Normal
■
Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■ Sync
Adjust this value if computer images appear blurry or flicker.
■
Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the
button to center it.
■ Progressive
For composite video, S-Video, component video, and signals
from the HDMI port only. Turn this setting on to convert
interlaced signals into progressive signals (best for still
images). Select
Video
for movie images, CG, and animated images.
Film/Auto
Leave the setting
Off
■
Noise Reduction
Smooths out rough images. Select the setting that makes the
selected input source look best. Epson recommends that you
select when viewing image sources with very low noise,
Off
such as DVDs.
■ HDMI Video Range
only)
When you connect to the HDMI input port, set the
projector's video range to match the video range setting of
your device.
■
DVI/HDMI Video Range
only)
When you connect to the DVI-D or HDMI input port, set
the projector's video range to match the video range setting of
your device.
and specify a resolution.
Manual
for viewing general video images. Select
for moving images.
(G5550NL/G5650WNL/G5950NL
(G5450WUNL/G5750WUNL
or
Wide
note
You can also use the remote
control's
automatically reset the
projector's Tracking, Sync,
and Position settings. See
page 155 for details.
pointer
note
For component or RGB
video, the Progressive setting
can only be adjusted when
480i/576i/1080i signals are
being input. However, the
setting cannot be adjusted
with 1080i signals when the
Aspect setting is
note
The Noise Reduction,
Progressive, and Overscan
settings cannot be set for
digital RGB signals.
Fine-Tuning the Projector
button to
Auto
.
Full
117