Epson PowerLite Pro G5450WUNL Installation Handbook

Epson PowerLite Pro G5450WUNL / G5550NL /
G5650WNL / G5750WUNL / G5950NL
note
Turn o this product when
not in use to prolong the life
of the projector.
Do not turn the projector on
immediately after turning it
o . Turning the projector on
and o frequently may
shorten the life of the lamp.
note
Epson recommends that you
clean the air lter whenever
you replace the lamp.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury. If the projector has
been installed on the ceiling,
you should stand to the side
of the lamp cover, not
underneath it.
If the lamp is used after the
replacement period has
passed, the possibility that
the lamp may break
increases. When a lamp
replacement message
appears, replace the lamp
with a new one as soon as
possible, even if it is still
working.

Replacing the Lamp

The life span of the projection lamp is about 2000 hours if
in the Settings menu is set to
Consumption
3000 hours if
Power Consumption
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message
Replace the lamp
lamp comes on.
The light ashes orange.
Lamp
To maintain projector brightness and image quality, replace the lamp
as soon as possible.
You may also need to replace the lamp if the
red.
Lamp light
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L62
(G5450WUNL/G5550NL) or V13H010L63
(G5650WNL/G5750WUNL/G5950NL).
Follow these steps to replace the lamp:
1. Press the power button on the back of the projector to turn it
o . After the projector beeps twice, unplug the power cord.
2. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
INSTALLATION HANDBOOK
Power
(default), and
Normal
is set to .
ECO
appears on the screen when the
light ashes
Lamp
Maintenance
1