Instructions For Installation - Respekta KM 9130 T-28 Installation & User's Instructions

5.3

Instructions for installation

5.3.1 Size of work surface cutout area
Cut out the work surface according to the dimensions indicated in the drawing. For installation and use,
a minimum space of 50 mm (X) must be maintained around the cutout as shown in the illustration.
The thickness of the worktop must be at least 30 mm. To avoid deformations of the work surface that
could be caused by heat radiating from the hob, use heat-resistant material. Use the sealing tape as
shown in the illustration.
WARNING: The work surface material should be made of impregnated wood or other
insulating material.
H
X
B
Model
KM 9130 T-28
WARNING: Make sure that the hob is well ventilated and that the air inlet and outlet are
not blocked.
Make sure the hob is always in good condition.
en-34
sealing tape
L
D
X
L (mm) W (mm) H (mm)
290 520
W
X
D (mm) A (mm)
50 46 270
X
A
Fig. 5.1
B (mm) X (mm)
490 50 minimum