Fault-Finding; Part Setter - Renishaw Primo Manual

Fault-finding

Part setter

Symptom
The part setter fails
to power up (no
LEDs illuminated).
Reduced range.
The part setter
crashes.
Cause
No credit token.
The credit token was inserted
incorrectly.
Dead battery.
Unsuitable battery.
The battery was inserted
incorrectly.
The battery was removed for too
short a time and the part setter has
not reset.
Poor contact between the battery
cover mating surfaces and the
contacts.
There is local radio interference or
obstruction.
Radio link failure or the part setter
is out of range.
The workpiece is obstructing the
path of the part setter.
The part setter's length offset is
missing.
Action
Insert a credit token (see page
5.29).
Check the credit token insertion
and polarity (see page 5.30).
Change the battery (see page 6.2).
Change the type of battery being
used (see page 6.4).
Check the battery insertion and
polarity (see page 6.2).
Remove the battery for a minimum
of 5 seconds (see page 6.2).
Remove any dirt and clean the
contacts before reassembly (see
page 6.2).
Identify the source of interference
or obstruction and remove it.
Check the position of the interface
and remove any obstructions (see
page 5.1).
Review the software and the
program (please refer to the
programming manual).
Review the software and the offsets
(please refer to the programming
manual).
7.1