Renishaw Primo Manual page 75

Symptom
The machine stops
unexpectedly during
a probing cycle.
The interface error
LED is lit during the
probing cycle.
The interface low
credit/low battery
LED is lit yellow.
The interface low
credit/low battery
LED is lit red.
Cause
Radio link failure or the part setter
is out of range.
Interface or machine fault.
Dead battery.
Exhausted credit (a yellow LED will
be shown on the part setter, see
page 5.19).
The part setter is unable to find the
target surface.
The stylus was not given sufficient
time to settle from a rapid
deceleration.
A false probe trigger.
The part setter is not switched on
or it is in hibernation mode.
Radio link failure or the part setter
is out of range.
Dead battery.
The part setter and interface are
not partnered.
There is low credit in the system (a
flashing yellow LED will be shown
on the part setter, see page 5.18).
The part setter battery is low (a
flashing blue LED will be shown on
the part setter, see page 5.18).
Action
Check the position of the interface
and remove any obstruction (see
page 5.1).
Check the interface error code (see
page 5.24) and the machine user's
guide (please refer to the machine
tool documentation).
Change the battery (see page 6.2).
Insert a new credit token into the
part setter (see page 5.29).
Check that the part is correctly
positioned and the stylus has not
broken (see pages 5.2 and 5.3).
Add a short dwell before the
probing move (the length of dwell
will depend on the stylus length and
rate of deceleration). The maximum
dwell is one second (please refer to
the programming manual).
Enable the enhanced trigger
filter (see page 2.2 and 3.5) and
recalibrate the part setter (please
refer to the programming manual).
Review the switch-off method (see
page 2.2) and the program.
Check the position of the interface
(see page 5.2) and remove any
obstructions.
Change the battery (see page 6.2).
Partner the part setter and the
interface (see page 5.30).
Replace the credit token in the part
setter soon (see page 5.30).
Replace the battery in the part
setter soon (see page 6.2).
7.3