164
|
Maintaining and Transporting the Printer
Caution: Don't run a
cleaning cycle while
thick media is loaded in
the printer.
Checking and Cleaning the Print Head Using the Control
Panel
You can print a nozzle check from the control panel and examine it to
determine whether any nozzles are clogged or deflected. Then you can run a
cleaning cycle if necessary.
1. Press r
.
Menu
2. Press d until
TEST PRINT
selected.
3. Press r
then press
,
4. After the pattern is printed, use at least a 10
If the pattern looks good, as shown below, the print head is clean.
•
If any dots or segments are missing or deflected, as shown below,
•
run a cleaning cycle as described on page 165. Then print another
nozzle check pattern to make sure the nozzles are clean.
If the nozzles are still clogged after three cleaning cycles, run a power
•
cleaning cycle as described on page 165.
Automatically Checking and Cleaning the Print Head
The printer automatically checks the nozzles and cleans them if necessary.
You can specify how often you want this to happen or turn this feature off.
You can also have a nozzle check pattern printed on a regular basis, so you
can check it yourself.
1. Press r
.
Menu
PRINTER SETUP
2. Press d until
AUTO NOZZLE CHECK
164
is selected, then press
to start printing the nozzle check pattern.
OK
is selected. Press r again.
is selected, then press r.
.
NOZZLE CHECK
r
×
eye loupe to examine it.
is