Using Maintenance Mode - Epson Stylus Pro 7900 User Manual

172 | Maintaining and Transporting the Printer

Using Maintenance Mode

Maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use
maintenance mode to do the following:
Change the language or units of measurements used on the printer's
•
control panel menus.
Adjust the maximum value for roll paper tension.
•
Run a "super strong" cleaning cycle.
•
Return all of the printer's control panel settings to their default values.
•
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the
hold it until the printer turns on and the LCD displays
MAINTENANCE MODE.
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
To change the language on the LCD display, press d to highlight
•
LANGUAGE
want, then press
mode and returns to normal operation.
To change the units of measurement, press d to highlight
•
, then press r. Press d to switch from
UNITS
, then press
FEET/INCH
To change the temperature units of measurement, press d to
•
highlight
TEMPERATURE UNITS
from (Celsius or centigrade) to
C
select it. Press
To change the maximum roll paper tension, press d to highlight
•
ROLL PAPER TENSION
maximum value, or u to increase it (from 1 to 5). Press
the setting you want.
172
button, then press the P Power button and
, then press r. Press d until you see the language you
to select it. The printer exits maintenance
OK
to select it. Press
OK
F
when done.
l
, then press r. Press d to decrease the
to
METRIC
when done.
l
, then press r. Press d to switch
(Fahrenheit), then press
OK
LENGTH
to
OK
to select