Advertisement
Select your Load balance mode.
MAC address - Aggregated group will balance the traffic based on different MAC addresses. Therefore, the
Load Balancing
packets from different MAC addresses will be sent to different links.
Mode
IP/Mac Address - Aggregated group will balance the traffic based on MAC addresses and IP addresses. Therefore,
the packets from same MAC addresses but different IP addresses will be sent to different links.
Name: Enter the name of the LA Group.
Type: Use the drop down menu to specify the type for LAG.
● Static- The static aggregated port sends packets over active member without detecting or negotiating with
Edit Group
remote aggregated port.
● LACP- The LACP aggregated ports place member into active only after negotiated with remote aggregated port
for best reliability.
GE: Click on port to check / uncheck which ones will be part of this LAG.
LAG Port Settings
In this page, the user can Enable the Link Aggregation Group and add Description as well as specifying the speed and the flow
control for LAG.
Port
The selected LAG to be configured.
It is used to configure the information description for this LAG , which can be a description of usage, etc., with a
Description
maximum of 128 characters, and the characters limited to input are numbers 0-9 , letters az / AZ and special
characters.
Set whether to enable the interface.
Port Enable
it is enabled by default.
Link Aggregation Group
Link Aggregation Port
Link Aggregation – Port Settings
Advertisement
