Table of Contents
Advertisement
Bringing Out of Storage
•
Remove any covers from the engine, air filter
and exhaust pipe.
•
Fill the engine with the correct quality and
viscosity oil into the engine, as necessary, refer
to Technical Data, Lubrication System. Install a
new oil filter if the filter was not changed during
conservation.
•
Install new fuel filters and bleed the fuel system.
•
Check the drive belt(s).
•
Check the condition of all rubber hoses, and
retighten the hose clamps.
Conservation of the lubrication and fuel systems for more than 8 months' stoppage:
•
Drain the engine oil and fill up with conservation
oil* to just over the MIN marking on the dipstick.
•
Connect the fuel suction and return hoses to a 1/3
full jerrican containing conservation oil* and 2/3
diesel fuel.
•
Bleed the fuel system.
* Conservation oils are sold by oil companies.
47713625 06-2021 © AB VOLVO PENTA
•
Close the drain taps and install any drain plugs.
•
Check the coolant level. Top up as necessary.
•
Connect the fully charged batteries.
•
Start the engine and warm it up at fast idle with
no load.
•
Check that no oil, fuel or coolant leakage occurs.
•
Fill the AdBlue/DEF tank. The solution must
fulfill ISO 22241 standards.
•
Start the engine and run at a fast idle until about 2
liters (0.6 US gal) of the fluid in the jerrican have
been used. Stop the engine and re-connect the fuel
suction and return lines.
•
Drain the conservation oil from the engine.
•
Follow the other instructions on the previous page.
Storage
71
Advertisement
Table of Contents
