Table of Contents
Advertisement
Installing and replacing option cards
The Contivity 4600 has six slots for option cards (see
section provides instructions on adding new option cards to the gateway or, if
necessary, replacing an existing card. The following procedure is for Nortel
Networks trained service personnel only.
Table 9
Table 9 Supported option cards for the Contivity 4600
Option card
Contivity Security Accelerator (CSA)
Hardware Accelerator
10/100 Ethernet LAN interface
1000BASE-T interface (copper)
1000BASE-SX interface (fiber)
ISDN BRI S/T or U interface
T1/E1 CSU/DSU WAN interface
Quad T1/E1 CSU/DSU WAN interface
V.90 modem interface
Single V.35/X.21 WAN interface
Dual V.35 WAN interface
HSSI WAN interface
1 The Contivity 4600 must be running Version 4.90 or later.
2 To support two Hardware Accelerator cards, the gateway must be running Version 4.76 or later.
3 The Contivity 4600 must be running Version 4.80 or later.
4 This option card is no longer available for purchase.
lists the option cards that you can install in the Contivity 4600.
1
3
3
4
Installing Hardware Options for the Contivity Secure IP Services Gateway
Chapter 7 Contivity 4600 option installation 97
Maximum
number
2
1
2
2
6
1
2
2
5
5
3
1
5
5
5
2
Figure 41 on page
96). This
Restrictions
Install two cards of either type,
or one card of each type. Do not
install the CSA card in slot 4.
Install two 1000BASE-T cards,
two 1000BASE-SX cards, or
one card of each type. Do not
install either card in slot 4.
Advertisement
Table of Contents
