LDG Z-100A Manual page 20

G6A
■Characteristics
Item Classification
Contact resistance *1
Operate (set) time
Release (reset) time
Min. set/reset signal width
Insulation resistance *2
Between coil and contacts
Between contacts of the
same polarity
Dielectric
Between contacts of
strength
different polarity
Between set and reset
coils
Impulse withstand voltage
Destruction
Vibration
resistance
Malfunction
Destruction
Shock
resistance
Malfunction
Mechanical
Durability
Electrical
Failure rate (P level) *3
G
6
Ambient operating temperature
A
Ambient operating humidity
Weight
Note: The data shown above are initial values.
*1. The contact resistance was measured with 10 mA at 1 VDC with a voltage drop method.
*2. The insulation resistance was measured with a 500 VDC megohmmeter applied to the same parts as those used for checking the dielectric strength (except
between the set and reset coil).
*3. This value was measured at a switching frequency of 60 operations/min and the criterion of contact resistance is 50 Ω. This value may vary, depending on
switching frequency, operating conditions, expected reliability level of the relay, etc. It is always recommended to double-check relay suitability under actual load
conditions.
4
Single-side Stable
5 ms max.
3 ms max.
−
1,000 MΩ min. (at 500 VDC); except for set-reset
1,000 VAC, 50/60 Hz for 1 min
1,000 VAC, 50/60 Hz for 1 min
1,000 VAC, 50/60 Hz for 1 min
−
1,500 V (10 × 160 μs) (conforms to FCC Part 68)
10 to 55 to 10 Hz, 2.5 mm single amplitude (5 mm double amplitude)
10 to 55 to 10 Hz, 1.65 mm single amplitude (3.3 mm double amplitude)
500 m/s 2
100,000,000 operations min. (at 36,000 operations/hr)
500,000 operations min. (at 1,800 operations/hr)
-40°C to 70°C (with no icing or no condenstion)
Single-winding Latching
50 mΩ max.
5 ms max.
5 ms max.
10 ms
−
1,000 m/s 2
300 m/s
10 μA at 10 m VDC
5% to 85%
Approx. 3.5 g
Low Signal Relay
Double-winding Latching
250 VAC, 50/60 Hz for 1 min
2