LDG Z-100A Manual page 8

7
Rear Panel Connectors
The rear panel of the Z-100A features four connectors.
ANT: Connect the 50Ω coax antenna feedline to the standard SO-239 connector.
GND (wing nut): Connect to antenna system ground if needed.
RADIO: Connect the 50Ω coax jumper cable from this standard SO-239 connector to the
Antenna jack on the rear of the transceiver.
INTERFACE: This 6-pin mini-DIN connector connects to the radio interface cable. DC power
is also supplied via this connector. Be sure to turn off the transceiver before connecting or
removing cables.