Table of Contents
Advertisement
MagneSafe V5
Example Get MagneSafe Version Number property Request (Hex):
Cmd Num
00
Example Get MagneSafe Version Number property Response (Hex):
Result Code
00
Track ID Enable Property
Property ID:
0x05
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x95
Description:
This property is defined as follows:
id
0
T
Id
0 – Decodes standard ISO/ABA cards only
1 – Decodes AAMVA and 7-bit cards also
If this flag is set to 0, only tracks that conform to the ISO format allowed for that
track will be decoded. If the track cannot be decoded by the ISO method it will
be considered to be in error.
T
00 – Track Disabled
#
01 – Track Enabled
10 – Track Enabled/Required (Error if blank)
This property is stored in non-volatile memory, so it will persist when the unit is
power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect. This
reader must be unplugged for at least 30 seconds to properly power cycle it.
Example Set Track ID Enable property Request (Hex):
Cmd Num
01
Example Set Track ID Enable property Response (Hex):
Result Code
00
Example Get Track ID Enable property Request (Hex):
Cmd Num
00
30
Data Len
01
Data Len
03
T
T
T
3
3
2
2
Data Len
02
Data Len
00
Data Len
01
Prp ID
04
Prp Value
56 30 35
T
T
1
1
Prp ID
Prp Value
05
95
Data
Prp ID
05
Advertisement
Table of Contents
Need help?
Do you have a question about the MagneSafe V5 and is the answer not in the manual?