How To Use This Table - Oki ML4410 User Manual

The value of the variables n1 and n2 must be within the ranges specified
in the following table. Values outside these ranges will be ignored.
CPI 10
n1 0 n1 134
n2 2 n2 136
n2 n1 + 2

How to Use this Table

When setting the right margin at 10 CPI, the right margin (n2) must be set
at least two characters to the right of the left margin (n1). Therefore, n2
must be greater than or equal to n1 + 2; (n2
Setting the left margin does not affect the right margin. It does clear all the
Horizontal Tabs and resets them every 8 characters starting with the new
margin as position 0.
The left margin depends on the pitch at the time of setting. If the character
pitch is changed the left margin will not move to accommodate this
change.
Even if the printer is set to proportional mode, the column width will still
be set in normal character size.
Note:
Any graphics data after the right margin will be lost.
With text this is not the case. Should text exceed the
right margin, the first character that goes beyond the
limit set will become the first character on the next
line.
The Set Vertical Format Unit command has the same function as the
Vertical Tab set (ESC B) but for 8 different channels (n= 0 . . .7). In this
way it is possible to define up to eight groups each with up to 16 vertical
tabs which can be called up with the select Vertical Format Unit command.
Vertical format unit
Set vertical format unit
Select vertical format unit
This selects one of the 8 Vertical Format Units that were set up with the
command 27/98/n/m1...m16/0. Where n is the number of the channel (n=0
to 7), and m is a specific line number and can be from 1 to 255.
60
12 15
0 n1 160 0 n1
3 n2 163 3 n2
n2 n1 + 3 n2 n1 + 3 n
Decimal
27 98 n 1B 62 n
m1...m16 0 m1...m16 00
27 47 n 1B 2F n
17
192 0 n1 229
195 4 n2 233
2 n1 + 4 n
n1+2).
Hex. ASCII
ESC b n
m1 ...m16 NUL
ESC / n
20
0 n1 251
4 n2 255
2 n1 + 4
Comp.
F
F
User's Guide