Line Spacing; Fine Line Spacing - Oki ML4410 User Manual

Formatting Features
Set page length by number of lines per
page
Set page length by number of inches per
page
Set Top Of Form (TOF) at current print
head position
Advance paper to next TOF

Line Spacing

Unless changed, the printer is normally set to print 6 lines per inch (LPI);
the distance from the bottom of one letter to the bottom of the one below
is 4.23 mm (1/6 inch). If more lines are required on a page, use the 8 LPI
command (3-mm (1/8 inch) spacing), or the 2.45 mm (7/72-inch) spacing.
The 8 LPI command is mostly used in 7-Bit Graphics.
Line Spacing
Set lines at 8 LPI
Set lines at 10.2 LPI 27 49

Fine Line Spacing

For graphics or special effects, use the fine lines per inch commands,
which change the spacing in multiples of 1/72 inch or 1/216 inch. This
does not affect the height of characters; it changes only the spacing
between the lines. For example, if a fine lines per inch of 72/72 inch is
selected, there is 1 inch between the bottom of one line and the bottom of
the next. To set lines per inch in multiples of 1/72 inch, first use:
Fine Line Spacing
Set LPI in multiples of 1/72 in 27 65 n
The last code "n" is the multiple you require and is a number with a
decimal value greater than 1 and less than 85.
For the Epson Mode that is all you need to do. For the IBM modes you
must also activate the lines per inch set using:
Fine Line Spacing
Activate fine line spacing 27 50
This command activates the fine lines per inch set by the CHR$(27);"A";
CHR$(1-85) command. These two commands are used to return to 6 LPI
by having CHR$(1-85) equal 12 (12/72 inch equals 1/6 inch line spacing.)
38
Decimal Hex.
27 67 n 1B 43 n
27 67 0 n 1B 43 00 n ESC C NUL n PF
27 52 1B 34
12 0C
Decimal Hex. ASCII Comp.
27 48 1B 30 ESC 0 P F
1B 31 ESC 1 P F
Decimal Hex.
1B 41 n ESC A n P F
Decimal Hex. ASCII Comp.
1B 32 ESC 2 P
ASCII Comp.
ESC C n P F
ESC 4 P
FF P F
ASCII Comp.
User's Guide