Table of Contents
Advertisement
Prop. Spacing: Change the setting to yes if you want to use proportional
spacing of characters when printing.
Rcv. Buffer: Sets the amount of printer memory for holding received data.
Selecting a larger size allows large jobs to be sent to the printer and
reduces the time the computer is busy sending data to the printer. If the
computer has problems with device time-outs, select a smaller buffer size.
Registration 1 to 7: Change the settings as required to obtain the best
registration for bidirectional printing. Normally 0 is the best setting, but
choosing another value may compensate for registration problems with
some graphis software packages.
Reset Inhibit: Select yes if your software package or computer sends an
initialisation command at the start of each print job. This initialisation
command normally resets any features that have been set on the printer.
SI Pitch (10): IBM mode only - sets the pitch to be engaged when the
printer control panel is set for 10 CPI and the SI command is received.
SI Pitch (12): IBM mode only - sets the pitch to be engaged when the
printer control panel is set for 12 CPI and the SI command is received.
Size: Change to double for double width and height printing.
Skip Over Perf.: Change to yes if you want the printer to go to the next
page when it comes within 25 mm of the bottom of the page. Set to no if
your software has its own page formatting controls.
Slashed Letter O: If set to yes, a slashed capital Ø and lower case ø appear
at locations 9Bh and 9Dh respectively in USA code page. If set to no, the
characters ¢ and ¥ appear at these locations.
Style: Change to italics if you want the printed characters to be slanted.
Time Out Print: If your software spends a long time processing between
portions of data it feeds to the printer, change the setting invalid to keep
your printer from inadvertently dumping any received data in the buffer
while it is waiting to receive more data.
Zero Character: Select slashed when it is necessary to distinguish
between a zero (0) and a capital or upper cae O.
Parallel Interface
The following options are used when the parallel interface is selected.
Auto Feed XT: Epson mode only - if your system uses pin 14 of the
parallel interface to control automatic line feed, change the setting to valid.
20
User's Guide
Advertisement
Table of Contents
