Case IH Steiger 370 CVT Service Manual page 74

Front axle system

Table of Contents

Powered front axle - Dynamic description - 500 and 600 Series

Steiger® 470 Quadtrac®

Steiger® 500 Quadtrac®

Steiger® 540 Quadtrac®

Steiger® 580 Quadtrac®

Steiger® 620 Quadtrac®

The axle assembly and components are very heavy. Dry weight of the axle assembly is 2232 kg (4920 lb). Be sure

all lifting devices and/or support stands are in good shape and have the capacity to lift and/or support the applied load.

The center housing for the differential must be rotated to different positions several times during the disassembly and

assembly procedures. For this reason it is recommended that the differential housing assembly should be mounted

in a rotating type repair stand such as the Revolver Repair Stand. If a rotating repair stand is not available, axle repair

should be performed on a clean concrete shop floor with access to an overhead hoist.

Clean and inspect all components and parts during the disassembly procedure for damage or wear. Replace any

damaged or worn parts found.

The axle is metric designed. Gaskets are not used for sealing flange joints in this axle. Use only anaerobic type

sealant on all mating surfaces requiring sealing. Follow label directions for cleaning and usage

All repairs to the axle will require that the axle assembly be removed from the tractor frame. ALWAYS refer to the axle

model, part number and serial number when ordering replacement parts.

Axle identification

The axle model number and serial number are stamped on a metal plate attached to the axle assembly in the

location shown. Always reference these numbers before ordering replacement parts.

Axle identification plate designations

Front axle system - Powered front axle

Plate identification

RCPH10FWD131FBJ

Differential lock

48193194 12/10/2017

25.1 [25.100] / 68

Show Quick Links

Table of Contents